How to pass the technical inspection (a) on its own.


Every car owner is again in a year or two issue run or buy a technical inspection. Of course, undergo technical inspection on your own, you can. Everything just depends on the model year of the vehicle. If the vehicle is less than seven years, the technical inspection certificate is issued by TRAFFIC POLICE for two years, further technical examination is held once a year. If you bought a car with the hand, and the technical inspection card still has a decent length, it can be changed at any point of the technical inspection without an inspection of your car! You can check the body and engine numbers.
 

The first thing one should start preparing the car for technical inspection is to check the validity of the first-aid kit, a fire extinguisher and a warning triangle. It is important that the vehicle complies with the norms of tinting the GOST, and more specifically the front glass of the car, including the frontal, is obscure to 30%, and back to 100% dimming is allowed. Plus the width of Sun-protection strips at the top of the windscreen shall not exceed 140 mm. Many items of technical inspection required to bring the vehicle in its purest form, including the license plate on the chassis and engine. Next, move on to the technical features of the technical inspection. All lights on the lighting devices have to work the corners glow of headlamps must meet the standards on GOST. Windscreen cleaning system should work completely correctly. Beep should buzz buzz signal GOST timbre does not regulate, but it should not be like a special signal. All the fluids in all containers under the hood should be within the normal range. Seat belts should work, the rear straps must be removed from under the seats. Rubber protector should not be less than three millimeters from the cutoff. Tires should be the season that comes at the time of inspection. In Sling caras for the car as a whole do not drip-free oil or other liquids. The exhaust system must not be leaks, you can mask the clamps. Play in the steering wheel must not exceed 30 millimeters, the same should not be heavy knocks in the shaking of the steering wheel. Handbrake should grab with 3-5 clicks, or you replace the pads or pull up the cable release. The brake force between all wheels must not vary greatly, and at the same time exceed the minimum threshold. To do this, replace the pads, if required by the mileage or pump the air bubbles in the brake system. Co-ch in exhaust gases should conform to the standards. For this converter, lambda probe oxygen sensor should be completely healthy. Usually they are caused by the wrong co-SN. All this is possible due to incorrect work and other sensors. The engine is very rarely affects it. If the vehicle carburettor needs to clean and adjust the carburettor. All additional equipment must have conformity certificates and approvals for the installation on that model of car, if not, you are wrapped in the troubleshooting. As alloy wheels, too, refer to the additional equipment. You can visit two of the technical inspection of a paid receipt. Next you will have to pay all and held again.