German Roding Roadster became the prey of the paparazzi. In 2009 at the Frankfurt motor show little-known company Roding put your prototype Roadster Concept. Machine, frankly, had a very specific appearance: the front panel "postcards" looked like they were carved with an axe, and the wheels were not hidden in the body, only covered with simple flaps. German office then promised to show production model in the coming years. And his word, as we have seen, holding back - just now hunters for hire, wrapped in masking tape, saw on the track Nordschleife test instance, which, however, was quite different from the concept two years ago. Well, skating rinks now - traditional wheel arches, and the lines are smoothed. Looks like the ugly duckling still turn into a beautiful Swan. The exterior of the car, by the way, is quite distinctive, although there are some similarities with the Audi sports car. But in this case more important than filling. The monocoque, the assurances of the representatives of the company, will be made of carbon fiber, and the front and rear subframes is made of aluminum and the above composite. Body panels are made from lightweight fiberglass, optionally made of plastic reinforced with carbon fiber. Roding Roadster Concept is a mid-engined durdurma will complete a six-cylinder turbo engine efficiency over 300 HP and 400 Nm is most likely the production of BMW AG engine (N54 or N55). Finished spider should bring for the upcoming motor show in Switzerland in March 2012.