Repair manual CHEVROLET LACETTI, DAEWOO NUBIRA III

Repair manual CHEVROLET LACETTI / DAEWOO NUBIRA III

The CONTENT presented in the book:
SECTION 1
THE STRUCTURE OF THE CAR
General information about the car
Passport data
Car keys
Management bodies
The instrument panel
The instrument cluster
Heating, air conditioning and ventilation of salon
Side door
Locks
Windows
The tailgate (boot lid)
The trunk
Seat belts
Seat
Adjusting the front seats
Rear seat
Using a child seat
Adjusting the steering wheel
Rear-view mirrors
Interior lighting
Sun visors
Stowage boxes of the salon and the electrical outlet
Hood
Control lever transmission
The trunk of the roof


SECTION 2
TIPS
Safety rules and recommendations
Rules tainiki security
Recommendations for use
Recommendations for traffic safety
Running car
The operation of the vehicle during the warranty period
Car preparation for departure
Filling the car with petrol
The use of the Jack
Towing
SECTION 3
THE FAULTS IN THE WAY
The engine won't start
Common methods of starting the engine
Of a fault in the starting system
Check the ignition system
Check the power supply system of the engine
Malfunction of the fuel injection system
Missing idle
Engine misfiring
Diagnostics of the engine on appearance of spark plugs
Car stutters
Spurt at the beginning of the movement
Jerks during acceleration
Jerks at a steady motion
Vehicle accelerates poorly
The engine stalled while driving
Dropped oil pressure
Check lubrication system
Engine overheating
Check the cooling system
The battery is recharged
Testing of electrical
Engine start from external power sources
Malfunction of electrical equipment
Appeared extraneous knocks
A knock in the motor
Knocks in the suspension and drivetrain
Vibration and shocks on rules wheel
Problems with the brakes
Bleeding the brake system
Check brake system
A puncture
Replacement wheels
SECTION 4
MAINTENANCE
General provisions
Safety
Daily maintenance (EO)
Check wheels
Checking and refilling oil in the lubrication system
Checking and adding coolant
Checking and refilling the brake fluid reservoir tormoznoi hydraulic actuators system and clutch
Checking and refilling fluid in the reservoir power steering
Checking and refilling fluid in the washer tank
Check external osvetitelnoi devices
The first maintenance (to-1)
Check belt accessory drive
Check the belt timing
Replace engine oil and oil filter
Cleaning the crankcase ventilation system
Check hoses and connections cooling system
System check exhaust cans
Check hermeticity fuel lines
Check linkage
Check oil level in manual gearbox
Check protective covers drives the front wheels
Check of a technical condition of details of the front suspension on the car
Checking the technical condition of the rear suspension parts on the car
Checking and adjusting the fragile wheel alignment
Inspection and steering on the car
Check free play (backlash) of the steering wheel
Check hermeticity hydraulic brakes
Check the degree of wear of the brake pads, discs and drums
Check the operation of the vacuum brake booster
Check the efficiency of braking system
Check the Parking brake
Service battery
Checking and adjusting headlamp
Grease valve body
Cleaning the drainage holes
The second maintenance (to-2)
Replacement filter element vozdushnogo filter
Replacing and maintaining spark plugs
Check high-voltage wires
Replacing the fuel filter
Belt replacement accessory drive
Replace drive belt tensioner and tensioner pulley
Changing the brake fluid in hydraulic brake and clutch
Replacement coolant
SECTION 5
ENGINE
Design features
Useful tips
Removing and installing decorative casing of the engine
Compression test the cylinders
Removing and installing the mudguards engine
Replacement mount the power unit
The installation of the piston of the first cylinder in the TDC position of the compression stroke
Removal, Troubleshooting and installation of flywheel
Replacement parts seal engine
Replacement prokladki cover cylinder head
Replacement prokladki the cylinder head
Replacement oil caps
Replacing the seals camshaft Vals
Replacing the seals on the crankshaft
Seal replacement oil pan
Replacement prokladki inlet pipe
Gasket replacement exhaust manifold
The cylinder head of the engine
Removal, Troubleshooting and installing camshaft Vals
Replacement hydrokompenser
Disassembly, repair and reassembly of cylinder head
Lapping valves
Removing the engine mounting
Engine repair
Disassembly of the engine
Troubleshooting of engine parts
Engine Assembly
Lubrication system
Design features
Removing and installing oil pump
Repair oil pump
Cooling system
Design features
Removing and installing electric fan radiator engine cooling Assembly with a casing
Replacement radiator cooling system
Water pump replacement
Removing and installing thermostat
Removing and installing expansion tank
Exhaust system
Design features
Replacement cushions suspension exhaust system
Replacement exhaust manifold
Removing and installing catalytic Converter
Replacement front pipe
Replacement muffler
Replace the main muffler
Removal and installation of termoarredo
The power supply system of the engine
Design features
Check the pressure system of the engine
Reducing the pressure in the supply system of the engine
Removing and installing air filter
and silencer intake
Withdrawal rement and installation
fuel pump
Fuel tank replacement
and its filling tube
Removing and installing the fuel rail
Removal, check and installation of injectors
Removing and installing throttle site
Adjustment and replacement
cable throttle actuator
Removing and installing pedals
throttle control
Checking and replacement of pneumomia drive
flap intake manifold
Removal, check and installation of the electromagnetic valve door actuator intake manifold
System EVAP
Features of the device
Removing and installing the charcoal canister system
EVAP
Removal, check and installation of the valve
produce canister
Recirculation system
exhaust
Design features
Removing and installing the EGR valve
SECTION 6
TRANSMISSION
Clutch
Design features
Check and adjust pedal travel
the linkage
Removing and installing clutch
The replacement of the working cylinder of a drive of deenergizing of clutch with release bearing
Replacing the master cylinder drive clutch
Replacement hose and brake pipes clutch
Removing and installing clutch pedal
The pumping hydraulic drive of deenergizing of clutch
Gear box
Design features
Checking, refilling and oil replacement in a manual transmission and the working fluid in the automatic transmission
Replacing the seals of the gearbox
Removing and replacing the gear box
Disassembly and Assembly transaxle Troubleshooting its parts
Repair of a secondary shaft
Repair primary shaft
Repair synchronizer
Repair differential
Rement of gear
Rement joints of the shift linkage
Removal, installation and resnt the scenes control lever transmission
Linkage adjustment transmission control
Drives the front wheels
Design features
Removing and installing drives the front wheels
Replacement of hinges of equal angular speeds of the drives front wheels
SECTION 7
SUSPENSION
Front suspension
Design features
Removing and installing struts front suspension
Rement struts front suspension
Replacement upper support struts of the front suspension
Replacing the ball joint front suspension
Replacement front control arm
Replacement parts stabilizer bar front suspension
Removing and installing steering knuckle front suspension
Replacement bearing front hub
Removing and installing the front suspension crossmember
Rear suspension
Design features
Removing and installing struts rear suspension
Repair struts rear suspension
Replace the top mount struts rear suspension
Replacement front lower arm rear suspension
Replacement rear lower arm rear suspension
Replacement trailing arm rear suspension
Replacement parts stabilizer bar rear suspension
Removing and installing the rear hub
Removal and installation of rear knuckle
Removal and installation of crossmember rear suspension
SECTION 8
STEERING CONTROL
Design features
Steering column
Removing and installing steering wheel
Removing and installing steering column shroud
Removing and installing steering column
Rods
Replacement outer tie rod end
Replacement tie rod end
Steering gear
Replacing the fluid and bleeding the system gidrousilitel delovogo management
Replace reservoir power steering
Steering gear replacement
Pump replacement power steering
SECTION 9
BRAKE SYSTEM
Features of the device
Bleeding the hydraulic brake system
Checking and adjusting the brake pedal position
Brake master cylinder
Replacement brake master cylinder reservoir
Replacement brake master cylinder
The vacuum brake booster
Replacing the vacuum booster
Replacement of hoses and tubes hydraulic brakes
Replacement brake hoses
Replacement of brake pipes
Removing and installing brake pedal
The brakes of the front wheels
Brake pad replacement brake front wheel
Replacement brake caliper of the front wheel Assembly with retaining frame
Replacing the brake disk of the brake mechanism of a forward wheel
Brake mechanisms of back wheels
Brake pad replacement brake rear wheel
Replacement brake caliper rear wheel Assembly with retaining frame
Replacing the brake disk of the brake mechanism of a back wheel
Parking brake
Adjusting Parking brake
Replacement brake pads of the Parking brake mechanism
Replacement equalizer Parking brake
The rear cable replacement Parking brake
Removal and installation of the lever of the Parking brake
Antilock braking system
Replacement speed sensors of the wheels
SECTION 10
ELECTRO EQUIPMENT
Design features
Fault diagnosis of electrical equipment
Mounting blocks
The location of the fuses, fusible inserts and the relay and replace them
Removing and installing Montaigne blocks
Rechargeable battery
Design features
Caring for the battery
Check state of charge of the battery
Removing and installing the battery
Charging the battery
Generator
Special design
Removing and installing the generator
Replacement alternator pulley
Repair of generator
Starter
Special design
Filmed and installing starter
Repair starter
The switch (lock) ignition
Special design
Testing of the switch (lock) ignition
Replacement of contact group of the switch (lock) ignition controller immobilizator
Filmed and installation of the switch (lock) ignition
The engine management system
Special design
Check the ignition coils
Filmed and installing of ignition coils
Filmed and installation of the electronic engine control unit
Checking and replacing the sensors engine management system
Lighting, sound and light alarm
Design features
Replacement lamps
Replacement of the headlight
Replacement of the side turn signal lamp
Replacement tail light
Replacement brake
Replacement of the lamps the number plate lighting
Replacement of interior lights
Replacement dome lamp trunk
Replacement of interior light glove box lamp
Replacement gear shift paddles
Shot and set the tone
Filmed and installation of slip rings for horn and driver's airbag
Replacement gear box motor wiper of a wind window
Replacement gear box motor wiper door hatchback
Filmed and installation of a washer of glass of a wind window and window glass tailgate
Window regulator front door
Replacement of control unit elektrosteklopodemniki
The replacement of the electric window regulators
Removing and installing blower motor radiator engine cooling
Removing and installing blower motor heater
Replacement of the additional resistance of the heater electrodentistry
Schreiberi window glass tailgate
The instrument cluster
Design features
Removing and installing instrument cluster
Switches instrument panel
Replacement of control unit electrocorrection lights and dashboard illumination
Replace the hazard switch
Removal and installation hours
The immobilizer
Features of the device
Removing and installing control unit immobilizer
Removing and installing cartridge cigarette lighter
Sound system
Removing and installing Automagnetola
Removing and installing speakers
Replacement of sensors and switches
Replacing the sensor signal lamp emergency pressure drop of oil
Sensor replacement fuel gauge
Test and replace backup light switch
Replacement brake light switch
Replacing warning lamp switch Park brake enable
Replacement switches of a plafond of illumination of salon
SECTION 11
BODY
Design features
Removal and installation of facing of a radiator
Removal and installation of lockers
Removing and installing bumpers
Removing and installing front bumper
Removing and installing rear bumper
Removing and installing front wing
Removal and installation of the grid boxes vozduhopritoka
Hood
Removing and installing the hood
Removal, installation and adjustment of the bonnet lock and drive
Adjustment latch hood lock
Side door
Removing and installing front door trim
Replacement glass front door
Replacement window front door
Replacement outer front door handle
Switch replacement front door lock
Replacement inside handle actuator front door lock
Replacement front door lock
Replacement ogranicena front door
Removing and installing front door
Removing and installing rear door trim
Replacement rear door glass
Replacement window regulator rear door
Replacement outer rear door handle
Replacement inside handle lock actuator rear door
Replacement rear door lock
Replacement ogranicena opening rear door
Removing and installing rear door
The tailgate
Replacing the stops on the tailgate
Removing and installing trim door
Removing and installing trim strips on the tailgate
Replacement of a lock, latch, handles and door lock switch of tailgate
Removing and installing the tailgate
Hatch filler pipe fuel tank
Remove and install hatch filler pipe fuel tank
Removing and installing lid lock hatch filler pipe fuel tank and its drive
Seat
Removing and installing front seat
Removing and installing head restraints
Removing and installing rear seat
Removal and installation of facing of a tunnel of a floor
Restraint system (SRS)
Design features
Removing and installing the driver airbag
Removing and installing airbag front passenger
Replacing front seat belt
Replacing rear seat belt
Removing and installing electronic control unit further passive safety system
Rear-view mirrors
Removing and installing exterior mirror
Removing and installing interior mirror
The instrument panel
Design features
Removing and installing instrument panel
Removal and installation of facings of salon
Removal and installation of facings of the trunk
The wiper of a wind window
Replacement wiper blades windscreen window
Replacing the wiper arm windscreen window
Removing and installing the trapeze wiper of a wind window assy with motoreductor
Wiper door hatchback
Replacement wiper blades window tailgate
Replacement wiper arm window tailgate
Removal and installation of the gear reducer wiper of the tailgate Assembly with bracket
Replacing the glazing of the body
Care of the bodywork
Car wash
Washing the engine compartment
Care of upholstery and floor mats interior
SECTION 12
DESIGN FEATURES OF THE ENGINE
General information
Check tension and replace the belt accessory drive
Checking and refilling oil
Oil change and oil filter
Replacement and adjustment of belt tension timing
The installation of the piston of the first cylinder in the TDC position of the compression stroke
Replacement cover gasket cylinder head
Seal replacement sump oil pan
SECTION 13
HEATING, AIR CONDITIONING AND VENTILATION
Special device
Features of the device of system of heating
Features of the device of the air conditioning system
Features of the device of the ventilation system
Rules equipment safe for repair and maintenance of air conditioning system
Remove refrigerant from air conditioning system
Replacement platalina rings
The a / C compressor
Removing and installing pressure regulator the a / C compressor
Removing and installing a / C compressor
Bearing replacement pulley
Replacement solenoid compressor clutch
Replacement condenser
Replacement of receiver drier
Replacement of thermostatic expansion valve
Replacement pressure sensor
Changing the filter entering the interior air
Removing and installing block manual control heating, ventilation and air-conditioning
Removing and installing actuator recirculation door
Otwarcia exhaust ventilation
APPLICATION
SCHEME OF ELECTRICAL EQUIPMENT


Attachment 6056 Attachment 6057 Attachment 6058 Attachment 6059



Download repair Manual CHEVROLET LACETTI, DAEWOO NUBIRA III on AutoRepManS:



https://autorepmans.com/images/downl...ir-manual.webp

Thanks for interesting manual. Unfortunately, it is not available via turbobit, because it always states "You have reached the limit of connections from your IP range". Can you add any other cloud download service? Thanks in advance!
Best regards!

Quote:

---

Originally Posted by dixy

Thanks for interesting manual. Unfortunately, it is not available via turbobit, because it always states "You have reached the limit of connections from your IP range". Can you add any other cloud download service? Thanks in advance!
Best regards!

---

Link for download - https://mega.nz/#!QhwH1CAL
Key in a Personal Message.

cual Is the key?

cual es la clave?